For single, adjustable gold tube bracelets, you’ll need:
Start by cutting the knotting cord into 2 12 inch pieces. Thread a gold noodle tube bead through one of the strands and cross the ends.
And now, all that’s left is the sliding closure! Similar to our macrame bracelet, fold the 2nd strand over the overlapping ends and start tying square knots. Fold the top cord over the bottom cord . . .
. . . and bring the top cord under both the bottom and middle overlapping strands through the loop, into a knot.
Repeat the same step on the right side.
Continue to make 5-6 more knots.
To finish the knots, thread one of the cords onto a needle and sew up the center of 2-3 knots along the backside. Pliers will help pull the needle through the tight knots.
Trim away any excess cord.
Thread two gold spacer beads onto each cord and tie the tips into a knot. Trim.
Your adjustable & colorful bracelets are done!